Uniden LTD 715 - Manual (Page 5)

18 19 2 0 2 1
22
18. TX (Transmit) - LED lights when transmitting,
19. DUAL (Dual Watch) - Indicates Dual Watch Mode.
20. HI (High) - Indicates transmitted output is 25 Watts.
21. LO (Low) - Indicates transmitted output is 1 Watt.
22. WX (Weather) - Indicates Weather Channels.
REAR PANEL CONNECTORS
23. Remote Speaker Connector - An external 4 ohm, 4 watt speaker
may be connected to this jack. The connecting wire must have a
miniature plug.
24. Antenna Connector - Connect the antenna here using a type
PL259 connector.
25. DC Power "Pigtail" and Connector - Connect supplied power cord
to the keyed connector.
OPERATION
1. Turn the unit On by rotating the VOL control clockwise.
2. Adjust the SQ control counterclockwise until you hear background
noise; then turn it clockwise until the noise just disappears.
DUAL WATCH
Dual Watch monitors Channel 16 for activity every two seconds while
scanning or monitoring.
To activate Dual Watch, Press DA/V while in any mode. The DUAL
indicator will appear on the LCD Panel, indicating Dual Watch Mode. If a
signal is received on Channel 16, the radio remains on Channel 16 until
the signal ends.
Press D/W again to cancel Dual Watch Mode.
MANUAL TUNING
To manually select a channel, rotate the Rotary Channel Selector to the
desired channel. Weather Channels are located on Channels 0 - 9.
Communication Channels are located on Channels 01 - 28 and 60 - 88.
TIMED SCAN (SEEK)
Press SCN to start SEEK (Timed Scan).
When SCN is pressed for the first time after the LTD 715 is turned on,
scanning will be in the SEEK (Timed Scan) Mode, and SEEK and DUAL
will display on the LCD Panel.
The radio scans for active Communication Channels except for Channel
16. (CH 16 is not included in the Scan cycle.)
Notice that Dual Watch is on automatically to cover CH 16 as well.
If there is too much activity on CH 16, and you vdsh to exclude it from
SEEK, Press D/W to cancel Dual Watch. (DUAL no longer displays on
the LCD Panel.)
In SEEK, the radio stops on the first active channel and stays on for 4
(four) seconds, then resumes Timed Scanning to the next active channel.