beautypg.com

Uniden, Warranty, Installation – Uniden PRO520E User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION

Plan the location of the radio and micro­

phone bracket before starting installation.
Select a location that is convenient for op­
eration and does not interfere with the

driver or passenger in the vehicle. The

radio should be securely fastened to a

solid surface using the mounting bracket
and s e l f - t a p p i n g s c r e w s w h i c h a r e
provided.

Mobile Antenna

Since the maximum allowable power out­
put of the transceiver is limited by the

D.O.C.. theantenna is a very important fac­
tor affecting transmission distance. It is for
this reason that we strongly recommend
that you install only a guality antenna in

your new C8 radio system. >bu have pur­

c h a s e d a superior guality transceiver.

Don't diminish its p e r f o r m a n c e by in­

stalling an inferior antenna.

Only a properly matched antenna system

will allow maximum power transfer from
the 50-ohm transmission line to the radiat­
ing element. We recommend that you use
an SWR meter when installing your an­
tenna. Set your PRO 520e to channel 20

and make adjustments to the antenna un­
til the meter reads as close to 1 as possible.
Vbur Uniden dealer is qualified to assist

you in the selection of the proper antenna

to meet your application requirements.

For

automobile

installation,

the

whip

antenna may be used with good effect.
The most efficient and practical installa­
tion is a full quarter wave whip antenna
mounted on the rear deck or fender top,
midway between the rear window and
bumper.

A short "loaded" whip antenna is more

convenient to install on your automobile.

although the efficiency is less than a full
quarter wave whip antenna.

For marine installation, consult your dealer

for information regarding an adequate
grounding system and prevention of elec­
trolysis between fittings on the hull and
water.

Connecting the Power Cord

With regard to the connection of the
power cords, it may be possible or de­

sirable to connect the red lead [for nega­
tive ground systems) or the black lead (for
positive ground systems) to the ignition
switch accessory terminal so that the radio
is automatically turned off when the ig­
nition switch (key) is turned off.

Alternately, the power lead may be con­

nected to an available terminal on the fuse

block or even to a point in the wiring
harness. Care must be taken, however, to
guard against a short circuit condition
When in doubt, please contact your ve­
hicle dealer for specific information about

your vehicle.

Ground Information

Most newer cars and small trucks use a ne­

gative ground system, while some older
cars and some newer larger trucks may
use a positive ground system. A negative

ground system is generally identified by

the ” battery terminal being connected
to the vehicle motor block, but if you can­

not determine the polarity of your vehicle,
consult your vehicle dealer for information.

NOTE: This radio may be installed and
used in any 12-volt DC negative or posi­

tive ground system.

Negative Ground System

If you are operating on a negative ground

system, connect the red DC power cord
from the radio to the positive " -i- " battery
terminal or other convenient point and
connect the black power lead to the chas­
sis or vehicle frame, or the negative
terminal of the battery.

Positive Ground System

If you are operating on a positive ground

system, connect the black DC power cord
from the radio to the negative " — " bat­
tery terminal or other convenient point
and connect the red power lead to the
chassis or vehicle frame, or the positive

" " terminal of the battery.

WARRANTY

TW O YEAR LIM ITED W ARRANTY

WARRANTOR. UNIDEN AUSTRALIA PTY. L TD. 345

Princes Highway, Rockdale, N.S. W. 2216 ("UNIDEN").
ELEMENTS OF WARRANTY. UNIDEN warrants, for

the duration of this warranty, its UNIDEN CB Product
to be free from defects in materials and craftsmanship
with only the limitation or exclusions set out below.

WARRANTY DURATION. This Warranty shall termin­

ate and be of no further effect Two (2) years after the
date of original purchase of the Product or at the time
the Product is (a) damaged or not maintained as rea­
sonable and necessary, (b) modified, (c) improperly

installed, fd) is repaired by someone other Warrantor
for a defect or malfunction covered by this Warranty,
or (e) used in a manner or purpose for which the Pro­
duct
was not intended.
PARTS COVERED. This Warranty covers at! compo­
nents of the Products,
S 7A TEMENT OF REMED Y. In the event that the Pro­
duct does not conform to this Warranty at any time

white this Warranty is effective. Warrantor will repair
the defect and return it to you prepaid, without charge
for parts, service, or any other costs incurred by

Warrantor or its representatives in connection with

the performance of this Warranty. In addition, if the

Product contains a defect or malfunction which is not
repaired after a reasonable number of attempts by

Warrantor to repair the Product, the Productor defec­

tive component will at our discretion, be replaced

without charge, when the defective product is deliv­

ered to the warrantor at 345 Princes Highway, Rock­
dale, N.S. W. 2216 free and dear of all liens and en­
cumbrances. Please note that while the Product will

be remedied under this Warranty without charge.

THIS WARRANTY DOES NOT COVER OR PROVIDE

FOR THE REIMBURSEMENT OR PA YMENTOF INCID­
ENTAL OP CONSEQUENTIAL DAMAGES.

PROCEDURE FOR OBTAINING PERFORMANCE OF

WARRANTY. In the event that the Product does not

conform to this Warranty, the Product should be

shipped prepaid, to Warrantor at 345 Princes High­

way, Rockdale, N.S. W. 2216. THE ORIGINAL OR COPY

OF THE SALES RECEIPT OR OTHER VALID EVIDENCE
OF THE DATE OF THE ORIGINAL PURCHASE MUST

ACCOMPANY THIS PRODUCT.

uniden*

Australia Pty. Ltd

HEAD OFFICE:

34S Princes Highway, Rockdale,

Phone 599 3355

Fax; (02) 599 7657

BRISBANE
3/12 Randall Street,
Slacks Creek,
Old 4127
Phone 107] 290-1 188
Fax (071 808 42SI
MELBOURNE B TASMANIA
446-44B Bell Street.
East Preston,

VIC. 3072

Phone (03) 484-0373
Fax (03) 484 6057

N.S.W. 2216

PEfTTH

23 Geddes Street,
Salcatta,
W A. 6021
Phone (09] 344-3937
Fax (09] 349 8165

ADELAIDE

72-74 Halifax Street,

Adelaide

S.A. 5000
Phone (08] 223-4235
Fax (08] 223 1471

UTUA01317CB(SK)

© Copyright 1989 Uniden Corporation

Printed in the Philippines