Casablanca Fan Company Atria C18GXXXF - Manual (Page 13)

Atria
™
13
STEPS 8-9
RED and
BLUE wires
2 BLACK wires
2 WHITE wires
3 GREEN wires
Wire nut
Hanging the Fan
7
Hold the motor housing with both hands. Insert
the ball of the downrod into the canopy opening.
Check to ensure that the wires are not pinched. Rotate
the motor housing until the slot in the downrod ball
locks into the pin opposite the canopy opening.
Connecting the Wires
8
Trim the extra length from the motor wires. Be
certain to leave at least 6 inches of wire above the
downrod. Use a wire stripper (not included) to strip
½-inch of insulation from the end of each trimmed wire.
9
To attach the fan wires to the ceiling fixture
wiring, match the wire colors as described below,
hold the bare ends of the wires side by side, and
fully insert the wires into the wire nut. Secure by
rotating the wire nut in a clockwise motion.
Connect wires in the following order:
GREEN wires from mounting plate and downrod •
assembly of fan to GROUND wire of power source.
WHITE fan wire to WHITE neutral •
wire from ceiling outlet box.
BLACK power wire from fan to BLACK •
power wire in ceiling outlet box.
BLUE D1 optional fan wire to RED power wire •
(second hot wire) in ceiling outlet box.
NOTE: If the colors of your wiring differ from
that described, consult an electrician.
Inspect each wire nut to ensure that no bare wire is visible.
Test the connection by gently pulling on the wires. The wire
nuts should stay firmly in place, covering the bare ends.
STEP 7
Ball
Slot
Pin