Citizen Systems CD-S500 Series - Manual (Page 47)

47
Paper
Use the following printing paper in order to maintain printing quality and stabilize paper
feeding.
Appendix
es
Roll paper Paper width: 76.2
±0.7mm (3±1/36 inch)
69.5
±0.6mm (3±1/36 inch)
57.5
±0.5mm (2.26±0.02inch)
Roll diameter:
φ30mm to φ83mm
Core diameter: Interior diameter
φ10 mm, exterior diameter φ27mm or less
Paper thickness: 0.06 to 0.085mm
Weight: 52.3 to 64.0 g/m 2 (JIS P8124)
(45 to 55kg/1,000 sheets/788mm x 1,091mm)
Recommended paper: Register paper (Oji Paper Co., Ltd.) or equivalent
Pressure sensitive
paper
+2
–0
Non-carbon 2P/3P paper, 1 original + 1 copy /2 copies
Paper width:
76.2
±0.7mm (3±1/36 inch)
69.5
±0.6mm (3±1/36 inch)
57.5
±0.5mm (2.26±0.02 inch)
Roll diameter:
φ30mm to φ83mm
Core diameter: Interior diameter
φ10 mm, exterior diameter φ27mm or less
Paper thickness: 0.05 to 0.20mm
But the total thickness that can be cut is from 0.05 to 0.14mm.
Recommended paper: 2P NCR Super (Mitsubishi Paper Mills Limited) (prints in blue)
or equivalent
+2
–0
Cautions concerning the roll paper
Starting to wind the roll paper (interior end) processing (with center core)
It must not be folded and its internal diameter must be even.
It must not be rolled back.
There must be no glue on its center core.
It must be wound with its printing side facing outwards.
When it is 2P paper, there must be no glue between the top and bottom sheets.
In the case of 3P paper, there must be no glue on the top, middle, or bottom papers.
Use pressure sensitive paper with total thickness no greater than 0.20mm and remember
that the printer will not cut paper with total thickness greater than 0.14mm.
If you use pressure sensitive paper with total thickness greater than 0.14mm, either do
not use the cutter or else rewind the bottom paper with the rewinder to reduce the
total thickness (top paper + middle paper) to 0.14mm or less.