Apple Grr User Manual
Apple Hardware
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
. .. Vs.
INTRODUCTION
The Grappler'^'^'' Interface is a Centronics compatible
parallel interface for the Apple 11/11+ Computer. In
addition to advanced text features. It offers high
resolution dot graphics (HIRES) dump routines located in
firmware. These are easily invoked using simple control
commends.
There is no standardization among printer
manufacturers for dot graphics. Therefore, a specific
version of the Crappler interface was developed for
each type of printer. If you connect a printer to an
incorrect version of the Crappler, the text features
should still function properly. However, the graphics
commands wili have unpredictable results.
INSTALLATION INSTRUCTIONS
To install the Crappler, simply plug it into any slot
inside the Apple (except (S) as follows;
1 Turn off the power to the Apple. This is important to
prevent damage to the computer and the Crappler.
2. Connect the Crappler cable to the set ot pins on the
Crappler interface card. Make sure that all the pins
on the card go into the cable's matching holes. Also,
the cable should point away from the card (it will
only tit one way).
3. Remove the cover from the Apple. This is done by
pulling up on the cover at the rear edge (the edge
farthest from the keyboard) just until the two corner
fasteners pop apart. Don't lift the edge any further,
but instead slide the cover backward until it comes
free.
4. Inside the Apple along the rear edge of the circuit
board, there is a series of eight long, narrow sockets
called "slots." The leftmost slot (looking at the
computer from the keyboard end) is slot »*'0. The
adjacent slot is slot *1 and this is where most Apple
programs expect the Croppler to be.
5. Be sure the power is off. Insert the Crappler card into
slot *1 (or any other slot except zero) with a gentle
rocking motion until fully seated.
6. Pass the cable through one of the vertical openings
in the back of the Apple case.
7. Replace the Apple's cover. Slide the front edge of
the cover into place, and then press down ori the
rear corners until they pop into place.
8. Connect the Crappler cable to the printer.
t
Document Outline
- TEXT FEATURES
- TEXT COMMANDS
- GRAPHICS FEATURES AND COMMANDS
- CHART RECORDER MODE
- PASCAL AND CP/M COMPATIBILITY
- FOR ADVANCED PROGRAMMERS:
- MEMORY LOCATIONS USED BY THE GRAPPLER
- APPLEPLOT MODIFICATION
- “VISIPATCH”
- APPENDIX B
- DIP SWITCH SEniNGS FOR YOUR PRINTER
- ANADEX 950C5-95C}1
- CENTRONICS 7391
- EPSON MX-70
- EPSON MX-80: MX-8C5FT with Graftrax-80
- EPSON MX-lOO
- I.D.S. 440G • 445G
- NEC 8023
- MALIBU 200
- GRAPPLER™ PIN ASSIGNMENTS
- I.D.S. 460G • 560G OR PRISM 80 AND PRISM 132
- LIMITED WARRANTY