Clover Electronics CDR 4170 - Manual (Page 29)

5.3.6 REC SPEED
• Choose the REC SPEED in the ALARM OPTION menu by using the UP/DOWN buttons.
• Choose one REC SPEED among 01, 02, 03, 05, 10, 15, 30 and 60 IPS by repeatedly
pressing the ENTER button, if the REC RESOLUTION in the RECORD menu set to 720H
or 360H. It will be fixed to 120 IPS if the REC RESOLUTION in the RECORD menu set to
CIF.
5.3.7 ALARM OUTPUT
• Choose the ALARM OUTPUT in the ALARM OPTION menu by using the UP/DOWN
buttons.
• Select N/O (Normally Open) or N/C (Normally Close) by pressing the ENTER button.
5.3.8 ALARM BUZZER
• Choose the ALARM BUZZER in the ALARM OPTION menu by using the UP/DOWN
buttons.
• Select ON or OFF by pressing the ENTER button.
5.4 MOTION
- Choose
the MOTION in the MAIN SETUP menu by using UP/DOWN buttons.
- Press
the ENTER button and the MOTION menu will be displayed.
- Press
the ESC button to exit.
5.4.1 MOTION
• Choose the MOTION in the MOTION menu with the UP/DOWN buttons.
• Choose one among OFF, OSD and OSD+BUZZER by pressing the ENTER button.
• OSD or OSD+BUZZER should be selected for motion recording.
5.4.2 CHANNEL
• Choose the CHANNEL in the MOTION menu with the UP/DOWN buttons
• Choose a channel among CH1, CH2, CH3 and CH4 by repeatedly pressing the ENTER
button.
NOTE
The channels should be changed along with the SENSITIVITY and motion
AREA.
5.4.3 SENSITIVITY
• Choose the SENSITIVITY in the MOTION menu with the UP/DOWN buttons.
• Choose a SENSITIVITY among 0, 1, 2, 3, 4 and 5 by using the LEFT/RIGHT button. “0”
is lowest value and “5” is the highest value.
- 24 -