Crimestopper Security Products COOLSTART RS900ER - Manual (Page 6)

REMOTE ENGINE CONTROL
TIMED SELF-START MODE – EXITING THE VEHICLE:
1) Have engine running with the Key, then press the Start button or for RS901:model activate Green start input
wire.
2) Within 10 seconds press the valet/program button once.
3) Parking Lights will turn OFF for about 5 seconds, and doors will unlock.
4) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
5) To turn off the engine, press the remote start button or for RS901 model activate Green Start input wire. The
parking lights will flash 4 TIMES as a confirmation that the unit is in Timed Self-Start Mode.
6) The Vehicle will Start by itself every 4 hours until driven with key or started via remote control.
CONVENIENCE AND SAFETY FEATURES
OEM INTERFACE: (FACTORY UPGRADE)
The RS901 Series III Expansion Module includes a programmable interface feature that allows control of most
remote start features through an existing factory remote keyless entry system. The RS901 Expansion module can
be installed as an upgrade to a Factory Keyless Entry System. This is referred to in this manual as activating the
Green Start input. Pressing a button on the Factory remote 3 times will activate a start. This type of installation is
usually connected to the lock circuit in the vehicle, therefore pushing the lock button on the Factory Remote 3 times
will produce a remote engine start or turn off a remote started engine.
PASSIVE STARTER DISABLE:
This RS900/901 Series III includes a programmable feature to allow the Optional Starter Disable to activate
automatically 1 minute after the ignition is turned off. This feature may provide insurance discounts or meet
insurance requirements in your providence.
KEYLESS ENTRY (POWER DOOR LOCK CONTROL)
This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) through the
transmitter for safety and convenience. This feature may require extra labor and/or parts to install.
REMOTE LOCK / UNLOCK
1) Press the Lock or Unlock transmitter button as you leave or come near the vehicle.
2) Parking lights will flash twice for unlock and once for lock. If vehicle is remote started, engine will remain running
and lights will flash but return to solid indicating engine is still being controlled by the remote starter.
NOTES: Doors lock automatically when vehicle is Remote Started. Starter Disable/Anti-grind is also
enabled/disabled with the lock/unlock buttons. If an anti-grind/starter kill relay is installed on a vehicle without power