Bosch MSM 6 A 68 - Manual (Page 6)

en
Disconnect the power supply unit from the
mains before cleaning and assembling the
appliance, if a fault occurs or if the appliance
is not used for a prolonged period. Do not pull
the cord over sharp edges or hot surfaces.
Keep children away from the appliance.
Supervise children to prevent them from playing
with the appliance.
Do not allow persons (also children) with restric­
ted physical sensory perception or mental
abilities or with lack of experience and know­
ledge to operate the appliance unless they are
supervised or have been instructed in the use of
the appliance by somebody who is responsible
for their safety.
/f\ Risk of explosion!
Protect batteries from heat and fire.
/f\ Risk of fire!
Charge the base unit in the supplied charging
station and with the associated power supply
unit only.
Do not cover the power supply unit.
Remove highly combustible objects.
/t\ Risk of injury!
Do not use the hand blender with damp hands
and do not operate it at no load.
Operate the hand blender with original
accessories only. Caution when processing hot
liquids. Liquids may splash during processing.
If the appliance is used incorrectly, liquid may
leak out of the battery in the base unit. Avoid
touching the liquid.
Do not immerse the appliance in liquid above
the blender foot-base unit connection point.
/t\ Risk of injury from sharp blades/
rotating drive
Never grip the blade on the blender foot.
Never clean the blender blade with just your
hands. Use a brush.
Important!
Do not attaoh or remove the blender foot until
the applianoe is at a standstill.
Safety devices
Start lock-out
Prevents the appliance from being switched
on unintentionally.
Fig. 2
To switch on
• first press and hold down the safety button 3 ,
• then press the On button 2 . While operating
the appliance, you can release the safety
button 3 .
Overload protection
If the motor switches itself off while the
appliance is being used, the overload protection
feature has been activated. Possible causes:
- the food has jammed the blender blade,
- too much pressure exerted on the food
during the cutting process.
Eliminate the cause and switch on the appliance
again.
Operating the appliance
Charging station
Fig. 3
The charging station 6 can be placed on a flat
surface (Fig. 3a) or mounted on a wall (Fig. 3b).
To mount the charging station on a wall
(installation materials supplied as standard):
Fig. 4
• Pull the installation plate down and out of the
charging station and attach to the wall with
2 screws.
• Insert the charging station from above onto
the installation plate.
Charging the base unit
/t\ Attention!
Do not use any other oharger.
The Li ion battery proteoted against total
disoharge. If the applianoe is switohed on with
a disoharged battery, the applianoe is switohed
off by a proteotive oirouit.
The LED Q flashes.
Following automatio disoonneotion, stop
pressing the On button O. The battery may
be damaged.
Important information
Before using the appliance for the
first time, fully charge the base unit
(approx. 2 hours). The base unit may
become warm during the charging
process.
Fig. 5
• Insert power supply unit 7 .
• Insert base unit 1 into the charging station 6 .
When the appliance has been inserted, the LED
4 comes on. The battery is automatically tested.
The battery charge status is displayed by the
LED.
6 Robert Bosch Hausgeräte GmbH