Clarion DVS9755z - Manual (Page 12)

18
DVS9755z
In this chapter, the control unit buttons are used.
Selecting adjust mode settings
Adjust the settings to suit your sound system.
1. Press the [ADJUST] button to enter the AD-
JUST MODE.
2. Press the [ ] or [ ] [DISP] button to select
item to set.
Each time the [ ] or [ ] [DISP] button is
pressed, the indications change as shown
below.
Adjust automatic sound format identification
(FORMAT)
Set speaker to on or off
(SP-SEL)
Set speaker filter frequency
(FILTER)
Adjust speaker output level
(SP-GAIN)
Set speaker delay time
(DELAY)
Set Dolby digital
(Dolby D)
Set parametric equalizer
(P.EQ)
Press the [ADJUST] button to return to the
original mode.
•
A flow chart is shown on the next page.
*1. The display shows the settings made in the
Section, “Changing display settings” (11
page).
*2. When an is displayed at the end of a
setting, press the [ENT] button to enter the
adjust mode.
*3. When the illustration is shown, press
the indicated button (the [ENT] button in this
example).
*4. When [ ] is displayed to the left of the
adjusted value, press the [ ] or [ ] [DISP]
button to switch the setting.
*5. When the [VOL] buttons are not used within
1 sec, the adjustment value display is
switched.
*6. When [ ] is displayed to the left of the ad-
justed value, press the [ ] or [ ] [VOL] but-
ton to switch the adjustment value.
*7. The next item is displayed.
Setting acoustic features (ADJUST MODE)
Control unit button operations