Clarion DVS9755z - Manual (Page 11)

DVS9755z
17
Stopping playback
Press the [ ] button to stop playback.
• Press the [ ] button to start playback
from the location where playback was pre-
viously stopped.
• When the [ ] button is pressed again after
the disc has been stopped, the disc is
played back from the beginning.
Pausing playback
Press the [ ] button to pause playback. Nor-
mal playback is resumed when the [ ] button
is pressed again.
Skipping tracks (to locate the
beginning of a section)
Press the [ ] or [ ] button during playback.
The number of tracks corresponding to the num-
ber of presses are skipped and playback is re-
sumed.
• Press the [ ] button to start playback
from the beginning of the next track.
• Press the [ ] button to start playback
from the beginning of the current track.
When this button is pressed again within 1
sec, playback starts from the beginning of
the previous track.
Fast forward/fast backward
Hold down the [ ] or [ ] button during play-
back.
When one of these buttons is held down, fast
forward or fast backward starts within 1 sec.
Normal playback speed is resumed when the
button is released.
• Intermittent sound can be heard during fast
forward or fast backward playback.
• The [ ] and [ ] buttons are also used
to locate the beginning of a section. When
one of these buttons is held down for 1 sec
or less, the beginning of a section is located
and playback starts from there.
CD Operations
The operations described in this chapter are per-
formed using the remote control buttons.
Replacing discs
1. Slide the door downwards until a clicking
sound is heard.
The disc is now automatically ejected.
• If the disc is left as is and not removed, it
will automatically be retracted into the unit
after 15 seconds.
2. Insert the disc in the slot with the label side
upwards.
When the disc has been inserted halfway, it is
automatically pulled inside the unit.
• When an inserted disc is not automatically
played back, press the [ ] button.
• Dirt or dust on the data surface may gener-
ate read errors. Wipe the disc with a soft
cloth before insertion. If errors still occur,
remove the disc.
3. Close the door.
• Keep the door closed at all times to pre-
vent dust from entering the unit.
Playing back discs
Press the [ ] button to start playback. Press-
ing the [ ] button again stops playback.
Remote control unit button operations