Introduction – Bosch NKT 72 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Introduction
Please read these instructions COMPLETELY
AND CAREFULLY, They will save you time and
effort and help to ensure optimum cook-top
performance. Be sure to observe all WARNINGS.
These installation instructions are intended for use
by a qualified installer. In addition to these
instructions the cook-top shall be installed;
• In the United States, in accordance with the
National Electric Code/State and Municipal codes
and/or local codes.
• In Canada, in accordance with Canadian Electric
Code C22.1-latest edition/Provincial and Municipal
codes and/or local codes.
These shall be carefully followed at all times.
TOOLS YOU WILL NEED
The following tools are needed to install your new
cook-top:
• Tape measure and straightedge or ruler
• Pencil
• Phillips screwdriver
• Pliers
• Wire cutters and wire stripper
• r * hole saw
• Hand or saber saw
POWER REQUIREMENTS
The cook-top must be supplied with the proper
voltage and frequency. The cook-top must be
connected to a three wire or four wire, single phase,
240 or 208 volt, 60 Hz AC only electrical supply
on a separate circuit fused on both side of the line.
A circuit breaker or time-delay fuse sized not to
exceed the circuit rating of the appliance specified
on the serial/rating plate located on the bottom of
the cook-top is recommended.
The cook-top must be connected with copper wires
ONLY.
COUNTER PREPARATION
Counter space must be provided for installation of
your new cook-top. When choosing a location
consider the following IMPORTANT
CONSIDERATIONS:
• Cabinet storage space located above the
cook-top should be avoided, to eliminate the
risk of bums or fire caused by reaching over
heated surface units of the cook-top. If you
choose to install cabinet storage above the
cook-top, install a range hood that extends
out horizontally at least 5” (127 mm)
beyond the bottom front edge of the
cabinets.
• If you choose to install cabinet storage above
. the cook-top, do not store any item(s) that
could be of interest to children in the
cabinets above the cook-top. Children •
climbing on the cook-top could be seriously
burned.
• If you choose to install cabinet storage above
the cook-top, do not store heavy, hard
objects that if dropped could damage the
ceramic cooking surface in the cabinets
above the cook-top.
STEPS FOR INSTALLATION
The following pages provide a step by step guide
for installation of the cook-top arranged as
follows:
• Technical Data
• Preparing the Location, for 30” cook-top
• Preparing the Location, for 36” cook-top
• Attaching Fastening Rails
• Placmg the Cook-Top in its Location
• Electrical Supply
• Electrical Connections
• Final Check List
It is recommended that you have the electrical
wiring and hook-up of your cook-top performed by
a qualified electrician. After installation is complete
have the electrician show you where the main
disconnect is and which of the circuit breakers/fuses
are for the cook-top.