Sharp AF-S125NX - Manual (Page 6)

INSTALLATION INSTRUCTIONS
INSTALLATION
WARNING: Make sure the unit is turned off and unplugged before installing.
1
Cut the window sash foam seal (adhesive
type) to the proper length and attach it to
the underside of the window sash.See FIG.1.
Jamb
Slide the free end ("I "section) of the panel into
the cabinet as shown in FIG 3, & 4. Slide the
panel down. Be sure to leave enough space to slip
the top and bottom of the frame into the rails on
the cabinet.
NOTE: Top Rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of(5/16').
This is necessary for proper condensed water utilization
and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained!
2 Place unit on floor, a bench ora table. There is a
Left and Right Window Filler Panel-be sure to
use the proper panel breach side.When installed
the flange for securing the panel to the window sill will be
facing into the room.
A. Hold the Accordion panel in one hand and gently pull
back the panel beyond the ends of the frame. See FIG.2.
C. Once the panel has been installed on the side of the
cabinet, make sure it sits securely inside the frame
channel. Slide the top and bottom ends of the frame
into the top and bottom rails of the cabinet, FIG 5.
D. Slide the panel all the way in and repeat on the other
side.
NOTE: Ifstorm window blocks AC.see FI6.13