Sharp 2020215A0343 - Manual (Page 17)

BEFORE CALLING FOR SERVICE
IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECK
THE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE.
POWER PLUG CHECK
This air conditioner uses a fused power piug.
Aiways check the power piug before use. RESET------------
1 Press the RESET button. TEST-------------
2 insert the power piug into the waii socket.
3 Press the TEST button.
You wiii hear a CLiCK if the circuit breaker is
functioning correctiy.
4 Press the RESET button untii you hear another
CLiCK.
The circuit breaker is activated,power is suppiied,
and the air conditioner is now ready for use.
Do not attempt to use the air conditioner if the above procedure is
impossibie, as it is maifunctioning.
Disconnect the power piug and request service.
AIR CONDITIONER DOES NOT OPERATE AT ALL
• Is the unit plugged in or is the plug loose?
• Is the fuse blown or the circuit breaker tripped?
• Did you restart the unit within 3 minutes after a power failure? If the power was off
for less than 3 minutes, and you restarted the air conditioner within 3 minutes, a
protective device may cause the compressor to shut off, preventing cooling for
about 5 minutes.
AIR CONDITIONER DOES NOT PROPERLY COOL
• Is the MODE set to fan only Mode?
Cooling will not take place in the fan only mode. Change the MODE setting
• Is the filter clogged with dust?
A dirty filter can cause the cooling coils to freeze. If this happens, clean the filter and
replace. Run the air conditioner on the MED FAN setting until all ice dissipates.
• Is the temperature set properly?
If your room is too warm, adjust the temperature setting lower.
• Is the window exposed to direct sunlight?
Close curtains or blinds to minimize solar energy heating the room.
• Are the windows or doors open?
Close all windows and doors for maximum cooling.
17