To remove belt, To replace belt or brushroll, Belt or brushroll removal and replacement – Kenmore 401.39000 User Manual
Page 12: Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BELT OR BRUSHROLL REMOVAL AND REPLACEMENT
/tv
WARNING
Electrical Shock and Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit. Failure
to do so could result in electrical
shock or personal injury from vacuum
cleaner suddenly starting.
TO REMOVE BELT
Lay cleaner flat and flip cleaner to
expose nozzle base. Base should lay
flat and face up. To remove nozzle
guard, remove 6 screws.
Rotate/pivot the nozzle guard and pull
off.
Lift and remove brushroll. Dispose of
old belt.
TO REPLACE BELT OR
BRUSHROLL
Motor
Shaft
Slide belt onto motor shaft.
Place new belt in area of brushroll
without bristles.
With new belt in place, pull and slide
brushroll into nozzle making sure that
the brushroll end caps are in the correct
orientation. Rotate brushroll manually to
make sure belt is properly aligned.
Reposition brush cover and 6 screws.
Tighten screws securely.
1 2