Kenmore 580.76100 - Manual (Page 4)

ELECTRICAL REQUIREMENTS
OBSERVE ALL LOCAL CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUND PRONG,
ELECTRICAL GROUND IS REQUIRED ON
THIS APPLIANCE.
A 2S0“VOlt 60 Hz, AG only, 2QA fused and
properly grounded electrical supply is required.
A time delay fuse or time delay circuit breaker
is recommandeti. Use a dedicated dreuft,
serving only this appliance.
DO NOT USE AN EXTENSION CORD.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must
be grounded. This appiiance has a power
supply cord with a 3-prong grourrding plug. To
minimize possible shock hazard, the cord must
be plugged into a mating grounding type wall
receptacle and grounded in acoardaiic® with
the National Electrical Code {ANSI/NFPA 7 0 )
latest edition and all local codes and
ordinances, if a mating wall receptacle is not
available, it is the personal responsibility and
obligation of the customer to have a property
grounded 3-prong wail receptacle Installed by a
qualified eiectrician.
115V- 230V-
Power ootid may irrdude a currant interrupter
device. A test arid reset butt!» is provided on the
piuo case. Th« device ^oulcf be isstad on a
psfiixlk! basis by first prassins the TEST hufttm
and Biart th® RESET butiort. If tte TEST button:
(toes not Wp or it the RESET button will not slay
engaged, dlscorstlnue use of the air oonditiorter a:nd
contact a. qualified service techntaian.
NCyfE! The shape may be dlferent acoording to its rttodei.
Use Wall Receptacle Power Supply
Standard 125 V,
f l V )
grounding
\ H y recaptacl» mtad
1SA, IffiVAC Us® Î5 AMPdime
delay fuse or IS AMP,
elKsutt breafter. /"■ X standard 2S0V,
f »“ *«" ] a-wire grawnding
1 ^ ; ?eü*pteds rated
15A,K30VAC
Standard 250V,
/ 1 mn\ 3-wire grounding
i ~ J reœptaas rated
20A,asOVAC
Use 20 AMP. time
(Way fuse or 20
MAP.
offciifebfeaitar.
^WAMNG
Efestrloitt Shock Hazard
Plug into a grosjided 3 prong outlst.
Do not remove grounet prong.
Do not use an adapter.
Do not use an extension oord.
Failure to fellow these instructions can rssuK in
death fire or ©lacWca! shock
ER CORD
You can choose between two methods below according to your window stool shape and preference.
USING SLIT “A" USING SLIT "B"
Fasten the stopper using 1 screw holes, and lead
out !he power cord through slit "A",
Fasten the stopper using toft screw hole, and rotate
properly to lead the power cord out through silt *B”.
-4-