Turn the vehicle’s engine off, Note, Closing the display – Pioneer AVX-7000 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Closing the Display
Turn the vehicle’s engine OFF.
The display will be automatically closed by the automatic close/open mode. If the display
does not close automatically, press the OPEN/CLOSE button.
Note:
• When closing the display, check to make sure that it has closed completely. If the display has
stopped halfway, leaving it like this could result in damage to it.
• The automatic close/open mode will operate the display as follows.
* When the ignition switch is turned OFF while the display is deployed, the display will be closed
after approximately 6 seconds.
When the ignition switch is turned ON again (or turned to ACC), the display will be deployed
automatically.
* Removing the front panel will close the display. (Refer to page 11.)
• The automatic close/open mode can be canceled. (Refer to page 11.)
• When the ignition switch is turned OFF after the display has been closed, turning the ignition
switch ON again (or turning it to ACC) will not deploy the display. In this case, press the
OPEN/CLOSE button to deploy the display.