Pioneer AVD-505 - Manual (Page 16)

Installation
5 . Fasten the mounting base onto
the dashboard with the tapping
screws.
Tapping screws
(3 X 12 mm)
A CAUTION
Before drilling any mounting
holes, confirm that the screws
will not interfere with any of the
vehicle’s operating systems (such
as the fuel line, brake lines, elec­
trical wiring, etc.).
6. Adjust the display vertical posi­
tion and display angle.
In order to stabilise the display, adjust
the display vertical position so that the
bottom of the display base contacts the
dashboard. Adjust the display to a
good angle for viewing.
If you turn this knob to the
left, you can adjust the
vertical position of the
display.
If you turn this knob
anticlockwise, you can
adjust the angle of the
display.
Note:
• After you have adjusted the display vertical
position and angle, turn the knobs clockwise
to fasten the display in place.