Pioneer AVD-505 - Manual (Page 10)

Connecting the System
Zbi CAUTION
• Pioneer does not recommend that you install or service your display yourself.
Installing or servicing the product may expose you to risk of electric shock or
other hazards. Refer all installation and servicing of your display to autho­
rised Pioneer service personnel.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare
wiring to remain exposed.
• It is extremely dangerous to allow the display lead to become wound around
the steering column or gearstick. Be sure to install the display in such a way
that it will not obstruct driving.
• Make sure that wires will not interfere with moving parts of the vehicle, such
as the gearstick, hand brake or seat sliding mechanism.
• Do not route wires where they will be exposed to high temperatures. If the
insulation heats up, wires may become damaged, resulting in a short circuit
or malfunction.
Before installing the unit
This unit is designed for vehicles with a 12-volt battery and negative grounding. Before
installing the system (especially in a recreational vehicle, lorry or bus), check the battery
voltage.
Disconnect the negative (-) terminal of the battery to avoid the risk of a short circuit.
To prevent damage
When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.