Kenmore 309000845 - Manual (Page 8)

Air Conditioner Features
(continued)
STEP 8 ~ TIMER-DELAY
START FEATURE: YOU WILL SEE:
DO THIS:
PRESS OFF
(If unit is running)
PRESS TIMER/OFF
Note: To do this, the unit must be in the off position.
When first set, the display will show .5. (one half hour),to increase the time up to 24 hours, go to step 9.
STEP 9 — TO INCREASE
DELAYED START TIME: YOU WILL SEE TIME CHOSEN:
Note: Tap or hold the UP arrow(A) to increase delayed start time by .5 hours (up to 10 hours), then in 1 hour increments up
to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.).
The unit will then come on in Cool and HI fan mode. The temperature maintained wflTbe the same as you previsouiy set. If you
want to change it, Press 'Cool" or "Power Saver Mode" pad, whichever you desire, then Up or Down arrows until the desired
temperature is indicated on the display. Pressing timer "On/Off" or after 5 seconds, the control will automatically change the
display back to the hours remaining until the unit will start.
Switching unit on at any time will nullify this setting.
STEP 10 — SLEEP FEATURE: YOU WILL SEE:
■ i* '
DO THIS:
PRESS ON/OFF
PAD
Note: In this "MODE" the selected temperature wiil increase by 2 degrees F 30 minutes after the mode is selected. The
temperature will then increase by another 2 degrees F after an additional 30 minutes. This new temperature will be maintained
for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" MODE and the unit will continue to
operate as originally programmed. The "Sleep" MODE program can be cancelled at any time during operation by pressing
"Sleep" MODE, "On/Off", "Fan Only" or the " \/ / /\" buttons, on either the Control or the Remote, "Time Delay Stop"
limit reached will also end "sleep" MODE.
8