Notes, Ycles, Ptions – Kenmore 465.1333 User Manual
Page 12: Ights
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Choose the cycle that best describes your dish load by pressing the corresponding touchpad (select models) or by
pressing the
Cycle select
pad (select models) until the desired cycle is lit. (See page 6, Start Up Guide, for how to
begin the cycle).
In addition to choosing a cycle, choose as many available options as necessary for your load.
• Cycles and options cannot be changed after the cycle has started.
• If Anti-Bacterial
(select models)
is selected, Sanl-RInse (select models) will automatically be selected
and can not be cancelled.
MC
ycles
, O
ptions
and
L
ights
dTFTOLESAA
MML
TT№PROX.bb'
m m .)
WASHES/RlNSES
Smart
Sense "*+
(select models)
An adaptive cycle that adjusts the
number of fills, wash times and
temperatures based on the turbidity of
the water. The turbidity sensor
determines the dish soil level and
selects the proper wash cycle.
Min. 57
Max. 138**
1 wash/2 rinses
4 washes/2 rinses
Sensor Dry
[select models]
Sani-Rinse+
[select models]
Fiigh Temp Wash
Delay Flours
Heavy Wash
A long cycle that uses more time, water
and applied heat than the Normal Wash
cycle.
80
4 washes/2 rinses
Fiigh Temp Wash
Delay Flours
Anti-
Bacterial+
(select models)
When the cycle monitor recognizes that
the proper conditions have been met, the
Sanitized light will activate at the end of
the cycle. Sanitization may not be
achieved if there is an interruption of the
cycle, power failure or if the incoming
water temperature is below 120° F (49° C).
80
4 washes/2 rinses
Sensor Dry
Sani-Rinse+
Fiigh Temp Wash
Delay Flours
Normal
Wash*+
A medium cycle for washing loads
with normal food soil levels.
Min. 57
Max. 95**
1 wash/2 rinses
4 washes/2 rinses
Sensor Dry
Sani-Rinse+
Fiigh Temp Wash
Delay Flours
China-
Gentle
Use this cycle for lightly soiled china
and crystal. This cycle uses a gentle
wash and rinse. Towel drying may be
required.
60
1 wash/2 rinses
Sensor Dry
Fiigh Temp Wash
Delay Flours
Quick
Wash
Quick cycle for light food soil. Towel
drying may be required
38
1 wash/2 rinses
Delay Flours
Quick
Rinse
Use this rinse cycle when rinsing place
settings you plan to wash later, or for
freshening up dishes that have been
stored for a period of time.
18
2 rinses
-
+ Only these cycles has been designated to meet NSF requirements (NSF/ANSI 184 Residential Dishwasher).
* Number of fills will vary depending on the soil level of each load.
**Times are based on immediate availability of 120° F hot water at the start of the cycle. This can be achieved by turning on the kitchen
faucet and running water until hot prior to starting the dishwasher.
Notes:
• All times are approximate.
• Fill length varies between different models.
• Fill time will vary depending on water pressure.
• Cycle times shown will increase or decrease based on each
load’s soil level, water temperature and selected options.
Fan dry can be 30 minutes up to 4 hours depending on
cycles selected. Dry time is optimized per cycle
performance by selecting Sensor Dry.
If the drawer is open for more than 30 seconds during the
intermittent drying time, intermittent dry will shut off
Even if rinse aid is used, the first few loads may leave
dishes with more water than normal. This effect will
dissipate after a few loads.
11