F. grounding / connect to electrical power, Install covers, Restart the water heater – Kenmore 180 User Manual
Page 40: Step by step guides to install
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3 .
.
I
STEP BY STEP GUIDES TO INSTALL
F. GROUNDING / CONNECT TO ELECTRICAL POWER
CONNECTING TRANSFORMER
PLUG IN THE TRANSFORMER
Plug the transformer into the electrical outlet.
FIG. 18
INSTALL COVERS
After installing your water softener, replace the cov
ers. For the UltraSoft 400 and UltraSoft 800, angle
the covers so the main cover clips onto the back first,
then bring down in front and clip on the 2 tabs inside
the rim of the salt hole and lower the salt cover clo
sed.
To drain the water heater, open a hot water faucet
and let it run until the water runs cold. Then close
the faucet.
RESTART THE WATER HEATER
TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT
Your new Sears softener is now softening the water
for your household needs. However, your WATER
HEATER is filled with hard water. To have fully
soft water right away, you can drain the water heat
er so it refills with soft water. If you don't drain the
water heater, it will take a few days before you have
fully soft water.
YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.
Now go to your owner's manual and do the softener start-up sieps.. .setting the timer, filling the
storage tank with salt, sanitizing, etc.
3 - 9
High Performance Valve