F. grounding / connect to electrical power, Install covers, Restart the water heater – Kenmore 180 User Manual
Page 20: Step by step guides to install
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3 .
.
I
STEP BY STEP GUIDES TO INSTALL
F. GROUNDING / CONNECT TO ELECTRICAL POWER
CONNECTING TRANSFORMER
PLUG IN THE TRANSFORMER
Plug the transformer into the electrical outlet.
FIG. 18
INSTALL COVERS
Cover
(Main)
After installing your water softener, replace the cov
ers. For the UltraSoft 100, first position the main
cover on the softener. Then, set the salt hole cover
into the main cover, and lower closed. For the Ultra
Soft 200, angle the covers so the main cover clips
onto the back first, then bring down in front and clip
on the 2 tabs inside the rim of the salt hole and lower
the salt cover closed.
To drain the water heater, open a hot water faucet
and let it run until the water runs cold. Then close
the faucet.
RESTART THE WATER HEATER
TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT
Your new Sears softener is now softening the water
for your household needs. However, your WATER
HEATER is filled with hard water. To have fully
soft water right away, you can drain the water heat
er so it refills with soft water. If you don't drain the
water heater, it will take a few days before you have
fully soft water.
YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.
Now go to your ozvner's manual and do the softener start-up steps...setting the timer, filling the
storage tank with salt, sanitizing, etc.
3 - 9
Deluxe Valve