B. install 3-valve bypass, B. installing 3-valve bypass -3, Step by step guides to install – Kenmore 180 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3 .
.
I
STEP BY STEP GUIDES TO INSTALL
B. INSTALL 3-VALVE BYPASS
INSTALLING 3 VALVE BYPASS AND PIPES
(EIG. 9)
Cut the house main water pipe where you will
connect the softener. Loosely put together pipe,
fittings, and the 3 valves. Place valve(s) within
easy reach.
IMPORTANT:
When looking at the front of the softener, the inlet
is on the right side. If water in your house main wa
ter pipe runs from left to right, be sure to use a
"cross-over" as shown on page 2-3.
When all pipe, fittings and valves make a good
fit together, tighten all threaded joints (use pipe
dope on outside threads), or solder all sweat
joints.
FIG.9
3 - VALVE BYPASS
(threaded plumbing shown)
to
softener
Inlet
3 - 3
High Performance Valve