Operating instructions, Continyed) check filter feature: you will see, Remote sensing feature (on some models) – FRIGIDAIRE Air Conditioner User Manual

Page 7: Heating feature(on some models); you will see

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Operating Instructions

(continyed)

CHECK FILTER FEATURE:

YOU WILL SEE;

Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will
illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off.

REMOTE SENSING FEATURE
(on some models);

LIGHT pulsing ( On & Off intermittently ).

NOTE: Unit display shows the set temperature

is actual temperature
at remote control only

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use
the " A V " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit

itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it
sends a signal. It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. If the unit
does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has
ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit.

HEATING FEATURE(on some models);

YOU WILL SEE;

temp/timer

auto

u hi

med

fan

speed

■

heat

cool

energy saver

fan only

mode

Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models). Timer, or Sleep Modes. When in

the "Heat" mode,the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between

55 °F(13 °C) and 80 °F(27 °C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room
air.