Typical undersink installation – Kenmore 625.3847 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

- STEP 5: INSTALL STORAGE TANK,

MAKE REMAINING TUBING CONNECTIONS -

scribed in Fig. 11, page 13.

CONNECT DRAIN TUBING, FAUCET TO

DRAIN ADAPTER; Referring to FIG. 8, run the loose
section (connected to faucet barb fitting) of black
3/8" tubing from the faucet to the drain adapter, with
a black collet, installed on page 6. Cut this tubing as
needed to route in as straight of a run as possible,
without loops, dips, low spots or kinks. Cut the end
of the tubing square. Then push all the way into the
fitting. PuU on the tubing to be sure it's held firmly
in the adapter fitting. See pages 12 and 13 for tubing

connection instructions.

2. CONNECT TUBING TO WATER SUPPLY: Con
nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as de-

3. Move the storage tank into place next to the RO as
sembly. You can stand the tank upright, or lay it on
side. Apply no more than 2 wraps of Teflon tape to
the threads on the nipple at the top of the tank. Hand
tighten the other included tubing adapter fitting
wdth the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUL NOT TO
CROSS THREAD.

4. Run the 3 / 8" yellow tubing to the fitting installed
in step 3, Be sure the end of the tubing is cut square,

and insert aU the way into the fitting. Again, pull on
the tubing to be sure it's held firmly in the fitting.

FIG. 8

TYPICAL UNDERSINK INSTALLATION