Install reverse osmosis filter assembly, Step 4 - install storage tank, Install storage tank – Kenmore REVERSE OSMOSIS 625.38556 User Manual

Page 11: Step 3-lnstoll reverse osmosis filter assembly, Step 4-lnstoll storage tank, Step 3 - install ro filter assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Step 3 - Install RO Filter Assembly

INSTALL REVERSE OSMOSIS FILTER ASSEMBLY

The Reverse Osmosis Filter Assembly can sit upright or lay

on its side. When planning your installation, you need to

allow adequate tubing lengths to be able to access the

back of the Reverse Osmosis assembly in order to change

the monitor battery. See Figure 11.

Step 4 - Install Storage Tank

INSTALL STORAGE TANK

1. Apply thread sealing tape to the threads on the nipple

at the top of the tank (max. 2 wraps). See Figure 12.

Locate the tubing connector. Tighten the tubing connec

tor with a wrench onto the tank nipple 7-8 turns, being

careful not to cross thread or overtighten. See Figure 12

3. Do not connect the tube at this time. This will occur

later in the assembly.

Place the storage tank next to the Reverse Osmosis

Assembly. The tank can be placed upright or on its

side.

tubing connector

tank nipple

storage tank

Figure 12

Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com