Kenmore 141.178600 - Manual (Page 11)

Attach the Pressure Cylinder Holder and Tank
Guide to the Cart Legs-Wheel Side of grill as
shown in Fig. 6 Align the tapped holes of both
parts with the holes on Side Panel. Secure firmly
using 4 of the 1/4"x1/2" Phillips head screws and
nuts provided.
Assembling The Grill Pulled-out Spice Tray
1. Install 2 of the 1/4''x1/2" Phillips head screws
to the rear of the Track. Without these screws
the Pulled-out Spice Tray will not stop properly.
2. Slide the Pulled-out Spice Tray into the Tracks
until it stops. See Fig. 7.
3. Install 2 of the 1/4''x1/2" Phillips head screws
to the front of the Track. This important step
prevents the Pulled-out Spioe Tray from being
pulled outside the tracks. See
Fig. 7.
Assembling The LP Gas Tank Hook
Installing The Grill Head
1. Now that you've assembled the grill oart you
can install the pre-assembled Grill Head. See
Fig. 8 To reduce the weight of the Grill
Head, we suggest you open the Grill Lid and
remove the packed components. Even with
the components removed, this step requires 2
people to lift and position the Grill Head onto
the grill cart. Be sure to align the 2 holes
beneath the hang ledge on each side of the
Grill Head with the 2 holes on each cross
brace of cart. Raise Grill Lid and insert 4 of
the 1/4"x1-3/8" Phillips head screws and lock
nuts and tighten securely.
2. From the back side of grill head, install the
Grease Draining Tray. See Fig. 8.
3 Center the Grease Receptacle under Grease
Draining Tray, See Fig. 8.
4. Install Rear Wind Shield between both Bowl
Side Panels by using 2 of the 1/4"x1/2"
Phillips head screws provided. See drawing
below.
Figure 6
Figure 7
Figure 8
GREASE
GREASE