Automatic shut off, Removing and emphing the water bucket – Kenmore 580.53650 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AUTOMATIC SHUT OFF
When the bucket is full, or when the bucket is not in the proper position, the Bucket Full light turns on
and the unit auiomaiically shuts olí.
Also, when bucket Is out of position, the unit will beep 3 times.
The bucket
must
be replaced In the proper position for the dehumidifier to work.. The light wllf
be on and Ihe dehumidifier will
not
run if the bucket Is not in file' proper position.
REMOVING AND EMPHING THE WATER BUCKET
The water bucket can be emptied
Empty the bucket manuaiy..
When the- bucket is lull,
remove and empty it into a
large sink or tub. When
finished, replace it properly.
NOTE: To replace the bucket
property, make sure the
siois on the back of bucket
are positioned^ correctly.
in one of three ways:
Place the ctehurnidifiar
directly
over
drain.
The bucket has a threaded
hose connection which can be
left open. Drill a 1/4(6.4m:m}
to 1/2"|13mm) hole In the
center of the hose connection.
Once opened, the hose
conneclion wifi continuaily
drain water from the bucket
Attach a garden hose to the
threaded buclcet drain hose
GOimsction to carry water to
the drain. |HAND
TIGHTEN
ONLY)
When being attached to the
bucket drain hose conneciioh,
be sure the hose doesn't kink
or bend. It should ii-e flat from
the dehumidifier to the drain.