Kenmore 580.53650 - Manual (Page 6)

OPERATION
вискет
Fua
40
Ч У К -фив»
HU^ÎDITY ‘-РйМ
COMTROi “ SFEED
i#0«E8'-
Low
4енг.
»4 Hr.
•■г Ht.
|Т111ЕЙ
CONTROL PANEL
Your dehumidifier controi panel contains a Bucket FuK indicatoit a Humidity indicator, a Power
Control, Humidity Controi, Fan Speed Control and Timer Control,
Bucket Ful! indicator —This light glows when- the water bucket is full- and needs to be emptied.
Power — Operation starts when this button is pressed and stops when the button is pressed again.
Humidity Control — This controls the hum'rtty in the room.
• 'Л : To raise the humidity setting
• v' : To lower the humidity setting
• The humidity can be set wlhin a range of 3Q% RH~70% RH by 5% increments.
Fan Speed This controls the speed of the airflow.
• High; Fart speed is set to high.
• Low: Fan speed is set to low.
• When Fan Speed button is pressed, the fan speed mode is changed.
Timer Control Press the Timer button to set the amount of lime you want the unit to' run,
• The Timer can be set for; Constant. 8 hour, 4 hour or 2 hour.
•
When Timer button is pressed, the Timer indicator lights shitt as follows:
Constant 2 hr. 4 hr. 8 Nr, Constar«
TO' OPERATE THE DEHO«©!FÍER;
1. Plug the power cord into an electrical outlet, Press the power button,
2. Set the Humidity Controi anywhere between 30% RH and 70% RH for normal operation,
ifyou heed more drier air, press the v' Humidity Control button.
If you need less moisture air, press the л. Humidity Control button.
3. Press the Power buttors to stop the unit manually.
4. Press the Timer button to set the amount of time you want the unit to run.
At the end of that time, the unit will shut off.
The Timer can be set for : Constant 8 hours, 4 hours or 2 hours.
5. if yO'U want to control the speed 'Of airflow, press Fan Speed button. Each time that the Fan Speed button
is pressed, the fan speed mode fe shifted: High Low -? High
Mote: Be careful not to fose the water bucket
This dehumidifier doesn't run if the water buctet is not installed properly.
-
6
-