Materials needed, Basle tools, Materials and basic tools needed – Kenmore POWER MISER 153.32154 User Manual
Page 5: Additional tools needed when sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Scars has available the installation
parts shown below; You may oi may not need all of these materi
als, depending on your type of installation.
WATER HEATER INSTALLA
TION KIT WITH FLEXIBLE
CONNECTORS FOR 3/4" OR
1/2" THREADED OR COPPER
PLUMBING
EXPANSION TANI» FOR THERMAL
EXPANSION CONDITIONS AVAILABLE
IN 2 GALLON AND 5 GALLON CAPACITY
THROUGH LOCAL SEAF^ STORE OR
SERVICE CENTER
DRAIN PANS AVAILABLE IN 20"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18" OR LESS,
24" DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 22"
OR LESS AND AVAILABLE IN 28”
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER U" OR LESS
Basle Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at youi local
Scars store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Folding Rule
Garvlen Hose
Drill
Pipe Dope or Teflon Tape
8 FOOT TAPE
GARDEN HOSE
SLOT-HEAD SCREW DRIVER
PIPE
WRENCH
PHILLIPS SCREWDRIVER
*C:
PIPE DOPE
(SQUEEZE TUBE)
ROLL OF TEFLON TAPE DRILL
(Use only on vmter connections)
ADDITIONAL
TOOLS
NEEDED
WHEN SWEAT SOLDERING
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Ennery Cloth
Wire Brushes:
HACKSAW
3/4" WIRE BRUSH
1/2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
ROLL OF EMERV
CLOTH
ñ
SOLDER
FLUX
PROPANE TORCH
FTÒ
hì
TUBING
CUTTER