Kenmore POWER MISER 153.32154 - Manual (Page 15)

Installation Instructions (cont’d)
Installation Checklist
'Whether 01 not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,
check the appropriate block within the model rating plate,
which is located adjacent to the lower access panel.
Is the fuse or circuit breaker sixe correct as shown in the chart
in the “Product Specifications” section?
Arc the wires from the circuit breaker or fuse service to the
water heater's junction box on the correct wire size (gauge) as
shown in the chart in the “Product Specifications” section?
Is the new tcmpcraturc'prcssure relief valve properly
installed, and piped, to an ad.equate drain? See “Temperature-
Pressure Relief’Valve” section.
Is the water heater completely fdled. with water? See “Filling
the
"Water Heater” instructions in the “Installation
Instructions” section.
Will a water leak damage anything? Sec “Facts to Consider
About the location” section.
Arc the cold and hoc water lines connected to the water heater
correctly? Sec “Water Piping” instructioas iu the “Instalktion
rascruccions” section.
Is there adequate clearance for maintenance around the water
heater?
Do you need to call your electric company to check your
wiring?
COLD
DISCHARGE PIPE
(Do not cap or plug)
6* AIR GAP
ELECTRIC ¥WIER HEATER
ego
OAFASn-y SEfilALWUWSBi:
1
yAtsM,. :
KRUtW HJKMeir !№№liU HlStllB í(iiSSíi»5ÍWWíC
ivHT . 150
WATTS wftTTfi ag
OPTIONAL WATTABe . .V, EQUff»P€D
iAAMWÜgy CHECK i ^
1
ífi'’'- IHSTRIJÍCTKSÍ
WMTB liMrrrB IF CONVERTED
MODEL RATING PLATE