Warmer drawer recommended food settings table, Food item setting, Setting warmer drawer controls – Kenmore 790.9643 User Manual
Page 16: Il^caution, A warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Warmer Drawer Controls
Arranging
Warmer
Drawer
(Warm
&
Ready™
Drawer)
Rack
Positions
(some models)
Note: Use the warmer drawer to keep hot foods hot such as:
vegetables, gravies, meats, casseroles, biscuits and rolls,
pastries and heated dinner plates.
The rack can be used in 2 ways:
•
In the
upright position
to allow low profile food items to
be placed both underand on top of the rack (for
example, roils or biscuits on top of the rack and a
casserole dish under - See Fig. 1 ).
•
in the
downward position
to allow you to place light
weight food items and empty dishware (for example,
rolls or pastries and dinner plates - See Fig. 2).
WARMER DRAWER
■■
NOTE: The warmerdrawer is equipped with a catch which may
require extra force when opening and closing the drawer.
To Operate the Warmer (Warm & Ready™)
Drawer
Always start with hot food. It is not recommended to heat
cold food in the warmerdrawer.
All food placed in the warmer drawer should be covered with
a lid or aluminum foil to maintain quality.
Do not use
plastic wrap to cover food. Plastic may melt onto
the
drawer and be
very
difficult to clean.
Use only dishes, utensils and cookware recommended for
oven use in the warmerdrawer.
il^CAUTION
! Always use pot holders or oven mitts when
removing food from the warmer drawer as cookware and
plates will be HOT.
To Set the Warmer (Warm & Ready™) Drawer
Thermostat Control
(some models)
The thermostat control is used to select the temperature of
the warmer drawer. It is located on the control panel (See
Fig. 3 on previous page). To set the thermostat, push in and
turn the knob to the desired setting. The temperatures are
approximate, and are designated by HI, MED and LO.
1. Turn the knob to select the desired temperature setting.
2.
For best results, preheat the drawer before adding food.
An empty drawer will preheat in approximately 15
minutes.
3. Turn the thermostat control to
OFF
after use.
Warmer (Warm &
Ready™) Drawer
Indicator Light
The indicator light is located
above the Warmer Drawer
thermostat control (some
models). It turns on when
the control is set, and stays
on until the control is turned
OFF. The warmer drawer is
inoperable during the Self
Clean cycle. The indicator
light will not come on during
the Self-Clean cycle.
NOTE: The warmer drawerwill NOT operate while in the
Self-Clean and “Oven Lockout” modes
Warmer (Warm & Ready™) Drawer
Temperature Selection
(some models)
Refer to the table in the side column for recommended
settings. If a particular food is not listed, start with the
medium setting, if more crispness is desired, remove the lid
oraluminumfoil.
Most foods can be kept at serving temperatures by using
the medium setting.
When a combination of foods are to be kept warm (for
instance, a meat with 2 vegetables and roils), use the high
setting.
Refrain from opening the warmerdrawerwhile in use to
eliminate loss of heat from the drawer.
Warmer Drawer Recommended Food Settings Table
Food Item
Setting
Hamburger patties, poultry & porks chops
Hi
Pizza, fried foods 8s bacon
Hi
Gravies, roasts (beef, pork & lamb)
MED
Vegetables &eggs
MED
Pastries, biscuits & hard rolls
MED
Rolls (soft) & empty dinner plates
LC
To Remove & Replace Warmer (Warm &
Ready™) Drawer
(some models)
A WARNING
Electrical Shock Hazard can
occur and result in serious injury or death.
Disconnectappiiancefromeiectricpower
before
cleaning and servicing the warmerdrawer.
16