Kenmore 37035 - Manual (Page 15)

VACUUM CLEANER STORAGE
Gather the cord and wrap it loosely around
the upper and lower cord hooks. Lock
power cord plug onto the power cord.
Store the vacuum
cleaner in a dry, indoor
area, on the floor with
the handle locked in the
upright position.
A
WARNING
Electrical Shock and Personal Injury
Hazard
Wrapping the cord too tightly puts stress
on the cord and can cause cord damage.
TROUBLESHOOTING :
Review this table to find do-it-yourself
solutions for minor performance problems.
Any service needed, other than
maintenance described in this Owner’s
Manual, should be performed by a Sears
or other qualified service agent .
A
WARNING
Disconnect eiecfrical supply before
performing maintenance to the
unit. Failure to do so could result in
electrical shock or personal injury.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner won’t run 1. Power cord not firmly plugged
into outlet.
2. Biown fuse or tripped breaker
3. Thermal Protector activated,
4. Needs service.
1. Plug unit in firmly.
2. Check fuse or breaker in home Replace
fuse/reset breaker
3. Allow cleaner to cool - Pg. 5
4. Take to Sears Service Center.
ptcic
up or low suction
1. OIrt container not instaiied
correctly.
2. Dirt container full
3. SnishroHwom
4. Belt is broken, worn or sitpped
out of position,
5. One or both filters ciogged.
6. Carpet height setting is
irrcoîrect,
7. Hose ciogged
8. Air directors need to be cleaned.
1. Review DIRT CONTAINER REMOVAL AND
REPLACEMENT-Pg. 11, 12.
2. Empty dirt container-Pg. 11,
3. Replace brushroll - Pg 13
4. Replace belt - Pg 13­
5. Remove filters and dean - Pg. 11,12.
8. Set carpet height adjust to appropriate
setting for carpet being cleaned - Pg. 9,
7. Check inlets, hose and dirt container for
obstructions; remove obstruction - Pg 14
If clog persists, call 1-877-839-2046.
a. Remove air directors and clean, Pg. 12.
Dust escaping
from cleaner 1. Dirt container full-
2, Dirt container not instalied
correctly.
3. Hose not installed correctly,
4, One or both filters not Installed
compieteiy.
1. Empty dirt container - Pg. 11,
2. Review DIRT CONTAINER REMOVAL AND
REPLACEMENT - Pg, 11,12
3. Review hose placement - Pg. 6.
4. Review filter removal at?d replacement -
Pg. 11,12.
Cleaner tools Won’t
pick-up 1. Hose clogged
2. Dirt container full,
3. One or both fliters dogged.
1. Check inlets, hose and dirt container for
obstructions; remove obstruction - Pg 14
If dog persists, call 1-877-833-2046,
2. Empty dirt container - Pg, 11,
3. clean filters - Pg. 11, 12.
Headlight not
working 1. Bulb burnt out
2, Loose electrical wires.
1. Replace bulb - Pg, 14.
2. Take to Sears Service Center.
Cleaner is difficult
to push 1. Carpet height sett! ng is
incorrect,
2. Belt is broken, worn or slipped
out of position.
1. Set carpet height adjust lever to appropriate
setting for carpet being cleaned - Pg, 9,
2. Replace belt - Pg 13
Performance
indicator light
turns red Hos6 cioggsd
2. Air directors need to be clear^ed.
1. Check inlets, hose and dirt conlainerfor
obstructions; remove obstruction - Pg. 14
if clog persists, call 1-877-839-2046,
2. Remove air directors and dean. Pg, 12. |
For any questions, please call 1-877-839-2046.
15