Connect the tubing to the refrigerator, Note, Turn the water on at the shutoff valve – Kenmore TRIO 795.785 User Manual

Page 31: Plug in the refrigerator, Start the icemaker, Connecting the water line

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONNECTING THE WATER LINE

9. CONNECT THE TUBING TO THE

REFRIGERATOR

NOTE:

* Before making the connection to the refrigerator, be

sure the refrigerator power cord is not plugged into
the wall outlet.

1. Remove the plastic flexible cap from the water valve.

2. Place the compression nut and ferrule (sleeve) onto

the end of the tubing as shown.

3. Insert the end of the copper tubing into the

connection as far as possible. While holding the
tubing, tighten the fitting.

A CAUTION:

Check to see if leaks occurs at water line

connections.

Tubing Clamp

1/4"

Compression

Nut

Ferrule
(sleeve)

1/4 " Tubing

10. TURN THE WATER ON AT THE

SHUTOFF VALVE

Tighten any connections that leak.

Reattach the compressor compartment access cover.

11. PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.

Refrigerator
Connection

A CAUTION:

Check to see if water dripping occurs at

water line connections.

12. START THE ICEMAKER

Set the icemaker power switch to the

position.

The icemaker will not begin to operate until it reaches
its operating temperature of 15“F (-9“C) or below. It
will then begin operation automatically if the
icemaker power switch is in the

I (on)

position.