Kenmore ELITE 790.99613 - Manual (Page 15)

The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged In, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure. See Figure 1).
Setting Oven Controls
Setting the Clock
PRESS
When PF appears in the display, press PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (^). "CLO" will appear in the display (Figure 2).
2. Press CZ) ^
(Figure 3). "CLO" will stay in the display. Press "CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day dispiay
1. Press and hold (^) for 7 seconds. "CLO" will appear in the
display. After 3 seconds ^ will appear In the display indicating
that the cooktop lockout is active (Figure 5). CONTINUE
holding the pad until "12h" (Figure 6) or "24h" (Figure 7)
appears in the display and the control beeps once.
Pfsss to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 6) or "24h"
(Figure 7).
Press to accept the change or press to reject the
change. Q will disappear from the display.
Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
2
.
3.
4.
©CD®
for 7 seconds
or
I
3-nn O C
C - U U r r
Figure 1
DISPLAY
Figure 6
iMh
Figure 7
15