Arranging oven racks, Removing & replacing oven racks, About the ceramic glass cooktop – Kenmore 9504 User Manual
Page 7: About the radiant surface elements, Before setting oven controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Setting Oven Controls
OVEN VENT
Oven Vent Location
For models equipped with ceramic cooktops, the oven vent is located under
the left rear side of the control panel. When the oven is on, warm air is
released through the vent. This venting is necessary for proper air circulation
in the oven and good baking results. DO NOT BLOCK OVEN VENT.
Arranging Oven Racks
ALWA YS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR
TO OPERATING THE OVEN).
Always use oven mitts when using the oven.
Removing & Replacing Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides
on the oven wails. Tilt the front of the rack upward and slide the rack back into place.
RECOMMENDED RACK POSITIONS FOR
BROILING, BAKING & ROASTING
Food
Rack Position
Broiling meats, chicken or fish
1,2 or 3
Cookies, cakes, pies, biscuits & muffins
3 or 4
Frozen pies, angel food cake, yeast, bread,
casseroles, small cuts of meat or poultry
5
Turkey, roast or ham
5
rii
;2 :
y
42
About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of
the element outline on the cooktop. Heat is transferred up through the surface of the cooktop to the cookware. Only flat-
bottomed cookware should be used. The type and size of cookware, the number of surface elements in use and their
settings, are all factors that will affect the amount of heat that will spread to areas beyond the surface elements. The areas
surrounding the elements may become hot enough to cause burns.
ELEMENT ON
>o
LEFT
FRONT
oo
LEFT REAR
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As
the temperature rises, the element will glow red. To
maintain the selected setting, the element will cycle on
and off. The heating element retains enough heat to
provide a uniform and consistent heat during the off
cycle. The ceramic fixture thermally insulates the heating
element, concentrating heat in the heating zone. For
efficient cooking, turn off the element several minutes
before cooking is complete. This will allow residual heat
to complete the cooking process.
NOTE: Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning and Before
You Call checklist sections of this Use & Care Manual.
NOTE: Radiant elements have a limiter that allows the element to cycle on and off, even at the HI setting. This helps to
prevent damage to the ceramic smooth top. Cycling at the HI setting is normal and can occur if the cookware is too
small for the radiant element or if the cookware bottom is not fiat.