Kenmore GENIUS II 625.34867 - Manual (Page 6)

SECTION 1
WATER SOFTENER START-UP
1C. PROGRAM THE TIMER
when the transformer is plugged in, the model code
HF32, and a test number (example: A2.0) show in the
faceplate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
mt 30W
IfVfL LEVR
8
7
6
HFilc*
4
3
2
t
flP.O
I *1.110“
IC'UU
NOTE:
If HE- shows in the display, press the UP © or
DOWN 0 button until HF32 shows. Then, press the
#1 SELECT button to set, and change to the flashing
PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again. If other than HF32
shows, see page 19 to reset.
SOUND “BEEPER”: A “beeper” sounds while pressing
buttons for timer set-up. One beep signals a change in
the faceplate display. Repeated beeps mean the timer
will not accept a change from the button you have
pressed," telling you to use another button. For
example, while setting the hardness (step 2), the
beeper sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness
setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words...PRESENT TIME do not show in the
display, press the #1 SELECT button (FIG. 1) until
they do, or see the notes above.
■ Press the 0 UP/DOWN0 buttons to set the
present time. Press UP to move the display ahead;
press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
M.7 SH3MI
" *i' '
7
8
HOO"
PRESEWTTIC
4
3
2
t
M.r acnK
" '
7
6
in.MC"
lUOO
m csBunm
4
$
2
f
NOTE:
Each press of the UP/DOWN
buttons changes the time by 1
minute. Holding the buttons in
changes the time 32 minutes each
second.
SET WATER HARDNESS NUMBER:
■ Press the #1 SELECT button once to display 25
(flashing) and HARDNESS._________________
The grains per gallon (gpg)
hardness of your water supply is
on your water analysis report. Be
sure to enter water test results on
page 2, for future reference.
iS
6