Kenmore 790.7050 - Manual (Page 6)

important Safety instructions
IMPORTANT INSTRUCTIONS FOR CLEANING
YOUR RANGE
ii CAUTION Before manually cleaning any part of the
range, be sure all controls are turned OFF and the range is
COOL. The range may be hot and can cause burns.
• Clean the range regularly to keep all parts free of
grease that could catch fire. Pay particular attention to
the area around each surface burner. Do not allow
grease to accumulate.
• Kitchen cleaners and aerosols -— Always follow the
manufacturer’s recommended directions for use. Be
aware that excess residue from cleaners and aerosols
may ignite causing damage and injury.
• Clean ventilating hoods frequently — Grease should not
be allowed to accumulate on the hood or filter. Follow
the manufacturer’s instructions for cleaning hoods.
Grounding Instructions
Avoid fire hazard or electrical shock. DO
NOT use an adapter plug, an extension cord, or remove
grounding prong from electrical power cord. Failure to
follow this warning can cause serious injury, fire or death.
This appliance is equipped with a 3-prong grounding plug
for your protection against shock hazard and should be
plugged directly into a properly grounded receptacle. DO
NOT cut or remove the grounding prong from this plug.
For personal safety, the range must be properly grounded.
For maximum safety, the power cord must be plugged into
an electrical outlet that is correctly polarized and properly
grounded.
See the INSTALLATION INSTRUCTIONS packaged with this
range for complete installation and grounding instructions.
Grounding type
wall receptacle
Do not under any
circumstance, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong
grounding plug.
Conversion to L.P. Gas
A WARNING I Personal injury or death from electrical
shock may occur if the range is not installed by a
qualified installer or electrician.
ik WARNING I Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by a qualified
technician.
This appliance allows for conversion to Liquefied Petroleum
(L.P.) Gas.
If L.P. conversion is needed, contact your local L.P. Gas
provider for assistance. The L.P. conversion kit is provided
with this appliance and is located on the lower REAR (back
side) panel of the range. Before installing the kit be sure to
follow the L.P. Installation Instructions carefully.
If a 2-prong wall receptacle is the only available outlet, it is
the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wall receptacle
installed by a qualified electrician.