Cd(d, Setting, The clock – Kenmore 790.479 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press A beep will sound and PF will disappear.
Setting
the Clock
Setting the Clock
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (^). "CLO" will appear in the display (Figure 2).
2. Press
pads to set the time of day to 1:30 (Figure
3) . Press CsTARTy. The time of day will appearin the display (Figure
4) .
Changing between 12 or 24 hour time of day display
1. Press and hold (^) for 7 seconds. "CLO" and the current time of
day will appear in the display (Figure 2). A beep will sound and
"12h" (Figure 5) or "24h" (Figure 6) will appearin the display.
2. Press (g^ to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3.
Press ..START to accept the change or press to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
PRESS
CD(D®
for 7 seconds
; START
) or
{
stop
O-nn
IC'UU
Figure 1
DISPLAY
Figure 2
Ш
n n
LLU
Figure 3
Figure 4
Figure 5
Figure 6