Setting the clock, C-nn – Kenmore 790.479 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The KITCHEN TIMER and FLEX CLEAN pads control the Continuous Bake or 12 Hour Energy Saving
features. The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the
oven control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for
Continuous Baking.
INSTRUCTIONS
PRESS
DISPLAY
To set the control for Continuous Bake or 12 Hour
Energy Saving features
Setting the Clock
Setting Continuous Bake or 12 Hour Energy Saving
0^
for 10 seconds
Figure 1
Figure 2
Press and hold for 7 seconds (Figure 1). After 10 seconds
“12h” or “-h” will appear in the display and the control will beep
once (Figure 2).
Press (g) to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (Figure 2) in the display
indicates the control is set for the 12 Hour Energy Saving mode
and "--h" indicates the control is set forthe Continuous Bake
feature (Figure 3).
Press CsTART) to accept the change (Figure 4; display will return
to time of day) or
press
to reject the change.
Setting KitchenTimer
The KITCHEN TIMER (^^ pad controls the Kitchen Timerfeature. The Kitchen Timer serves as an extra timer in the kitchen
that will beep when the set time has run out. It does not start or stop cooking. The Kitchen Timer feature can be used during
any of the other oven control functions, except during a self-clean operation. Refer to “Minumum and Maximum Control Pad
Settings” for time amount settings.
INSTRUCTIONS
PRESS
To set the KitchenTimer (example: 5 minutes)
1. Press
will appear and "TIMER" will flash in the display
(|s)
(Figures).
2. Press the number pads to set the desired time in the display
(example (^^^). Press ^
start
:. The time will begin to count down
with "5:00" and "TIMER" will stay in the display (Figure 6). Note: If
■STARTS 1
or
Figures
lillllilll
Figure 4
DISPLAY
START :
Figure 5
c-nn
j-uu
3.
START, is not pressed the timer will return to the time of day after
25 seconds.
When the set time has run out, "End" and "TIMER" will show in
the display (Figure 7). The clock will sound with 3 beeps every 7
Figures
E nd
Figure 7
seconds until («If) is pressed.
To cancel the KitchenTimer before the set time has run out
Press (i^). The display will return to the time of day.
To Set Add 1 Minute Feature
The ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the pad is pressed, 1 minute is added
to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the pad is
pressed, the Minute Timerfeature will become active and will begin counting down from 1 minute. For further information
on how to set the Minute Timer feature see To Set the Minute Timer instructions above.
10