Consumer defined control features – Kenmore 790.479 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Consumer Defined Control Features
Setting Temperature Display — Fahrenheit or Celsius
The BROIL { Broil} and FLEX CLEAN pads control the Fahrenheit or Celsius temperature display modes. The oven
control can be programmed to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to
display in Fahrenheit. Note: both ovens will be changed at the same time.
INSTRUCTIONS
To change display from Fahrenheit to Celsius or
Celsius to Fahrenheit
1. Press (Broil) and hold for 6 seconds. A beep will sound, "550"
will appear "UPPER" and "BROIL" will flash in the display
(Figure 1). After 6 seconds a beep will be heard and "F" (Figure
2) or "C" (Figure 3) will appear in the display.
If "F" appears, the display is set to show temperatures in Fahrenheit
(Figure 2). If "C" appears, the display is set to show temperatures
in Celsius (Figure 3).
2. Press to switch between Fahrenheit or Celsius display
modes. The display will show either "F" (Figure 2) or "C"
(Figure3).
3. Press . START . to accept the change or press to reject the
change.
PRESS
DISPLAY
,^Broilj
for7seconds
Figure 1
, START y or
I
STOP
Figures
12