Materials needed, Basic tools, Additionai toois needed when sweat soidering – Kenmore THE ECONOMIZER 153.333545 User Manual
Page 6: Material needed
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these material,
depending on your type of installation.
2
I
%
WATER HEATER
iNSTALLATiON
KiT WiTH FLEXIBLE
CONNECTORS
FOR 3/4” (19.05 mm)
OR 1/2” (12.7 mm)
THREADED OR
COPPER PLUMBING
FLEXIBLE WATER HEATER GAS
CONNECTOR WITH FITTINGS
/
r
.
w
.
r t
;
Ñipóles
WATER HEATER HEAT
TRAPS HELP REDUCE
HEAT LOSS DUE TO
THERMAL SIPHONING
DRAIN PANS AVAILABLE IN 20” (508 mm)
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18” (457 mm) OR
LESS, 24” (610mm) DIAMETER FOR
WATER HEATERS HANflNG A DI/UI4ETER
22” (559 mm) OR LESS AND AVAILABLE
IN 28" (711 mm) DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 26”
(660 mm) OR LESS
EXPANSION TANKS FOR THERMAL EXPANSION
CONDITIONS AVAILABLE IN 2 GALLONS
(7.6 LITERS) AND 5 GALLONS (18.9 LITERS)
CAPACITY THROUGH LOCAL SEARS STORE OR
SERVICE CENTER
Basic Tools
You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.
• Pipe Wrenches (2) 14” {356 mm)
• Screwdriver
• Tin Snips
• 6’ (1.82 m) Tape or Folding Ruler
• Garden Hose
< Drill
• Pipe Dope or Teflon Tape
DRILL
SLOT-HEAD SCREWDRIVER
TIN SNIPS
PHILLIPS SCREWDRIVER
c
LrCPC
ROLL OF TEFLON
TAPE (USE ONLY ON
WATER HEATER
CONNECTIONS)
PIPE DOPE
(SQUEEZE TUBE)
USE FOR WATER AND GAS
CONNECTIONS
GARDEN HOSE
6FOOTTAF«
PIPE WRENCH
Additionai Toois Needed
When Sweat Soidering
• Tubing Cutters or Hacksaw
• Propane Tank
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes
5
TUBING CUTTER
HACKSAW
ñ
PROPANE
TORCH
ROLL OF
EMERY CLOTH
3/4” (19 mm) WIRE BRUSH
ROLL OF LEAD-FREE
1/2" (13 mm) WIRE BRUSH
SOFT SOLDER
SOLDER
FLUX