Kenmore 7861* - Manual (Page 10)

Note: The indicator light located above the (S) pad will glow
while the minute timer is active.
Setting Oven Controls
(cont’d)
Note: The minute timer does not start or stop cooking. It
serves as an extra timer in the kitchen that will beep when
the set time has run out. The minute timer can be used
alone or during any of theotheroven functions. When the
minute timer is in use with any other function, the minute
timer will be shown in the display. To view other functions,
press the pad for that function.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press
displayed.
2. Press the yv or'V' pad to increase or decrease the
set temperature.
To Set Control for Continuous Bake or 12
Hour Energy Saving
The oven control has a built-in 12 Hour Energy Saving
feature that will shut off the oven if the control is left on for
more than 11 hours and 59 minutes. The oven can be
programmed to override this feature forcontinuous baking.
To set control for continuous baking:
and hold the J\ or "V" to increase or decrease the time. 1. Press and hold (S) down for 5 seconds until tone is
To Cancel the Minute Timer before the set time has run
out: Press (§).
Note: To turn the time of day display OFF or ON in the
display press (©) and hold for 15 seconds (the control
will beep once) and then release.This feature does not
renriove the set time of day frorn the memory of the .
control. When the'display is turned OFF the time of day
pad is will re-appear for a few seconds any time the f P
touched. ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■^^
2
.
heard, "--------hr" will appear in display for continuous
cooking. The current time of day will return to the
display.
To cancel the Continuous Bake function, press (S)
and hold for 5 seconds until tone is heard. "12hr" will
appear in display indicating that the control has
returned to the 12 Flour Energy Saving feature.
a
Oven
Lockout
To Set or Change the Temperature for Baking
The oven can be programmed to bake at any temperature
from 170°F to 550°F (77° C to 287°C).
To Set the Controls for Baking:
1. Press Bake, "---------- " appears in the display.
2. Within 5 seconds, press the W or "V . The display
will show "350°F (177°C)." By pressing and holding
the j A. or 'V', the temperature can then be adjusted
in 5°F increments (1 °C if the control is set to display
Celsius).
3. As soon as the yV or pad is released, the oven will
begin heating to the selected temperature. When the
displayed temperature reaches the desired baking
temperature, the preheat indicator light will turn OFF and
the control will beep 3 times.
To Set Control for Oven Lockout
The control can be programmed to lock the oven doorand
lockout the oven control pads.
To set Control for Oven Lockout feature:
1. Press and hold for 3 seconds. “Loc” will appear in
display, the “Door Locked” indicator light will flash and
the motor driven door lock will begin to close
automatically. DO NOT open oven door while the
indicator light is flashing. Allow about 15 seconds for
the oven door to lock. Once the oven door is locked, the
current time of day will appear in the display.
2. To cancel the Oven Lockout feature, press (S)and
hold for 3 seconds. The control will unlock the oven
doorand resume normal operation.
Note: If any control padjs pressed while in the Oven
Lockout mode, “Loc”. will appear in the display until
the control pad is released.
4. To cancel baking, press (S).
To Change the Oven Temperature after Baking has
Started:
1. Press Bake and make sure the bake temperature is
10