Materials and basic tools needed, Materials needed, Basic tools – Kenmore 153.33439 User Manual
Page 7: Additional tools needed whlen sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parts shown below. You may or may not need all of these materb
als, depending on your type of installation.
VENT ELBOW
EXPANSION TANKS
FOR THERMAL
EXPANSION CONDI
TIONS AVAILABLE IN
2 GALLON AND 5
GALLON CAPACITY
THROUGH LOCAL
SEARS STORE OR
SERVICE CENTERS
WATER HEATER INSTAL
LATION KIT WITH FLEXI
BLE CONNECTORS FOR
3/4" OR 1/1" THREADED
OR COPPER PLUMBING
c
WATER HEATER STAND 24"xl4"xl8"
FOR USE WITH WATER HEATERS
INSTALLED IN RESIDENTIAL
GARAGES HAVING A DIAMETER 24"
OR LESS AND A RATED CAPACITY
75 GALLONS OR LESS
FLEXIBLE WATER
HEATER GAS CON
NECTOR WITH
FITTINGS
VENT PIPE
WATER HEATER HEAT
TRAPS HELP REDUCE HEAT
LOSS DUE TO THERMAL
SYPHONING
DRAIN PANS AVAILABLE IN 20" DIAME
TER FOR WATER HEATERS HAVING A
DIAMETER 18" OR LESS AND AVAIL
ABLE IN 28" DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 26" OR
LESS
Basic Tools
You may or may not need ail of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
• Pipe Wrenches (2) 14"
• Screwdriver
• Tin Snips
• 6 Foot Tape of Folding Rule
• Garden Hose
•Drill
• Pipe dope or Teflon Tape
CARDEN HOSE
6 FOOT TAPE
SLOT-HEAD SCREWDRIVER
PIPE
WRENCH
PHILLIPS SCREWDRIVER
TIN SNIPS
ROLL OF TEFLON TAPE
(USE ONLY ON WATER
CONNECTIONS)
PIPE DOPE (SQUEEZE TUBE)
(USE FOR WATER AND
GAS CONNECTIONS)
ADDITIONAL TOOLS NEEDED
WhlEN SWEAT SOLDERING
• Tubing Cutters or Hacksaw
• Propane Torch
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes
3/4" WIRE BRUSH
1/2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
PROPANE
TORCH
ROLL OF EMERY
CLOTH
SOLDER FLUX
TUBING
CUTTER