Crimestopper Security Products CS-2004DC - Manual (Page 4)

WIRING
BLUE WIRE: (-) HOOD/TRUNK TRIGGER
The Blue wire is used for a grounding hood pin switch, trunk pin or both. Connect to existing hood and trunk pin
switches that read ground when open. If no existing switches are available, install new pin switches if desired.
GREEN WIRE: (-) DOOR TRIGGER
Connect to Negative type door switches that read ground when a door is opened and 12 volts when all doors are
closed. In the case of isolated door triggers, you may need to run additional wires from other doors OR go directly
to the dome light.
VIOLET WIRE: (+) DOOR TRIGGER
Connect to Positive type door switches that show +12 Volts when the door is open and Ground when the doors are
closed.
PINK WIRE: (+) CARJACK INPUT
+
+12 V
PINK
OPTIONAL CAR JACK WIRING: SWITCH
HIDDEN BUTTON or
TOGGLE SWITCH
(Not Included)
Connect to a push button, toggle switch, or to a +12
Volt source to selectively activate Car Jack protection
features - See diagram on next page for example
wiring configuration. This wire is used to activate a
passive carjack trigger even if the Carjack features
are not turned on in the programming options. A
Carjack countdown will begin under the following
conditions: Ignition is ON (vehicle is running), the
button or toggle switch is pressed, and a door opens
& closes. Upon these 3 events, in that order, the
alarm will start a Carjack countdown. See “Carjack protection” section on page 19.
GRAY WIRE: (-) NEG. INPUT [COIL] FOR ON-BOARD 15A RELAY (Term #85, Step #1)
This input controls the function of an on-board relay. Connect to any desired Auxiliary or Optional wire from the
Brown 3-pin output harness. Connect the Gray wire to the Orange/Black for Dome light illumination, Brown/Black
for Auxiliary 1 or Red/Black for Auxiliary 2 function. (See diagram, next page)
WHITE/RED WIRE: (+/-) INPUT SOURCE FOR ON-BOARD 15A RELAY (Term #87, Step #2)
Connect to a +12 Volt source or Chassis Ground depending on the polarity of the circuit you are going to auxiliary
circuit or function you are going to activate with the Black/White output wire. Connect to +12V for Positive Circuits
or Chassis Ground for Negative circuits. This wire must be the same polarity as the Black/White wire. (See
diagram, next page)
4