Operating, Controls (cont’d.), Using your humidifier – Kenmore 758.15408 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating
the
Controls (cont’d.)
Speed Button
Q
This humidifier is equipped with a 3-
speed fan control. Initially depressing the
speed button will display the current
speed setting. Each push of the speed
button advances the mode through the
settings of
(HIGH) F3, (MEDIUM)
F2,
(LOW) F1 and (AUTO) A.
The selected setting Is displayed on the
digital readout. The higher the setting, the
faster water is evaporated and released
into the air.
F1 (LOW)
is the quietest
setting and is provided for conditions that
do not require a rapid evaporation rate.
When
(AUTO) A
is selected the
humidifier will determine the required fan
speed needed to bring the actual room
humidity up to the set humidity.
Speed Button.
Humidity
Control
m
This button allows you to adjust the
humidity to suit your needs. This humidifier
will automatically cycle on and off as
required to maintain the selected setting.
The readout displays both actual
(ROOM)
and desired
(SET)
humidity percentage
(%) settings when humidity control button
Is pressed. The
ROOM
readout has a
range of 20% to 95%. If the room humidity
level is equal to or less than 20% the
display will show a flashing 20.
The
SET
readout has a range of 25% to
65% and is adjusted in increments of 5%.
Initially depressing the humidity button
will display the current humidity setting.
Each additional press of the button
increases the setting by 5%. A
SET
point
of 65% operates the humidifier
continuously regardless of the
ROOM
reading. The humldistat that senses the
readings is located on the power cord.
Insure that it is free from obstruction.
Humidity
Button ,
Quiet Comfort
3CÌ
Using Your Humidifier
Refill Display
For maximum run time both the bottle
and the base should be filled. When both
the bottle and the base empties the
display alternates the room humidity
reading and “F” (FILL), informing
additional water is required. Also at this
time the unit will automatically switch into
DRY
OUT
MODE
and continue to run on
the lowest speed until the filter is dry.
-*
----------------
Quiet Comfort
r
J
/
J
Refill/Dry
Out
Mode
Display