Kenmore POWER MISER 153.33616 - Manual (Page 6)

Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
WATER HEATER
iNSTALLATiON
KiT WITH FLEXIBLE
CONNECTORS
FOR 3/4” (19.05 mm)
OR 1/2” (12.7 mm)
THREADED OR
COPPER PLUMBING
FLEXIBLE WATER HEATER GAS
CONNECTOR WITH FITTINGS
3/4 irt. N.RT. fi^T Trap Ni^Kies
WATER HEATER HEAT
TRAPS HELP REDUCE
HEAT LOSS DUE TO
THERMAL SIPHONING
DRAIN PANS AVAILABLE IN 20” (508 mm)
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18” (457 mm) OR
LESS, 24” (610mm) DIAMETER FOR
WATER HEATERS HAVING ADIAMETER
22” (559 mm) OR LESS AND AVAILABLE
IN 28" (711 mm) DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 26”
(680 mm) OR LESS
EXPANSION TANKS FOR THERMAL EXPANSION
CONDITIONS AVAILABLE IN 2 GALLONS
(7.6 LITERS) AND 5 GALLONS (18.9 LITERS)
CAPACITYTHROUGH LOCAL SEARS STORE OR
SERVICE CENTER
Basic Tools
You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.
Pipe Wrenches (2) 14” (356 mm)
Screwdriver
Tin Snips
6’ (1.82 m) Tape or Folding Ruler
Garden Hose
Drii)
Pipe Dope or Teflon Tape
DRILL
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
ROLL OF TEFLON
TAPE (USE ONLY ON
WATER HEATER
CONNECTIONS)
PIPE DOPE
(SQUEEZE TUBE)
USE FOR WATER AND GAS
CONNECTIONS
GARDEN HOSE 6 FOOT TAPE PIPE WRENCH
Additional Toots Needed
When Sweat Soldering
• Tubing Cutters or Hacksaw
• Propane Tank
• Soft Solder
• Solder Flux
• Emery Cioth
• Wire Brushes
TU8INQ CUTTER
HACKSAW
iK
PROPANE
TORCH
ROLL OF
EMERY CLOTH
3/4” (19 mm) WIRE BRUSH
ROLL OF LEAD-FREE
1/2" (13 mm) WIRE BRUSH SOFT SOLDER
SOLDER
FLUX