GE 165 D3080P027 - Manual (Page 14)

The Problem Solver
(continued)
PROBLEM POSSIBLE CAUSE AND REMEDY
CHIPPING OF CHINA Rough handling can cause chipping. Load with care. Make sure glassware and china
are secure and сапЧ jar ioose. (See page 8 for correct way to load glassware.) Make
sure tall glasses and stemware will clear the top of the tub when you push the rack into
the dishwasher.
Always use the top rack for delicate items.
SMALL AMOUNT OF
WATER STANDING
IN THE BOTTOM
OF THE TUB
Water around the outlet on the tub bottom at the back of the tub is normal. It is clean
water. It’s there to keep the water seal lubricated.
water WON’T PUMP
OUT OF THE TUB
If the entire bottom of die tub has water, you may have a drain problem. Clean the air
gap, if you have one. (See page 11.)
Check the kitchen sink. Is it draining well? %u may need a plumber.
If dishwasher drains into disposer, nm disposer to clear. Be sure disposer is not clogged.
SUDS IN THE TUB Sudsing detergents are not meant for dishwashers. USE ONLY AUTOMATIC
DISHWASHER DETERGENTS TO AVOID SUDSING.
To remove suds from the tub: Open the dishwasher. Let suds evaporate. Add 1 gallon
of cold water to the tub. Close and latch the dishwasher. Pump out water by slowly
turning the control dial until a drain period is reached.
Repeat if necessary.
DISHWASHER LEAKS Suds can cause unit to overflow. That’s why it’s so important to use a detergent that’s
uesigiicd for iiUiuiiiatic dishwashers.
If you need more help,,, cal!, toll free:
The GE Answer Center®
800.626.2000
consumer Information service
14