GE JKP45WP - Manual (Page 22)

Questions?
Use This Problem Solver
PROBLEM POSSIBLE CAUSE AND REMEDY
OVEN WILL
NOT WORK
.The circuit breaker in your house has been tripped, or a fuse has been blown.
• Oven controls not properly set.
OVEN LIGHT DOES
NOT WORK
• Light bulb is loose or defective. Tighten or replace.
.Control panel is broken. Call for service.
OVEN DOES NOT
COOK PROPERLY .Aluminum foil being used improperly in oven.
• Oven vent blocked,
.Oven shelf not level.
.Ineorrect cookware being used. Check the Baking Guide for cookware tips.
.Clock set ineorreetly.
.Controls set ineorreetly. Review each cooking section.
.Shelf position is ineorrect. Check Baking, Roasting and Broiling Guides.
OVEN WILL NOT
SELF-CLEAN .Oven temperature is too high to set self-clean operation. Allow the oven to cool to
room temperature and reset the controls.
• Probe is in oven.
OVEN DOOR WILL
NOT OPEN
.Oven must cool below locking temperature (approximately 30 minutes after the clean
cycle is complete).
OVEN NOT CLEAN
AFTER CLEAN CYCLE .Oven controls not set properly.
.Heavily soiled ovens require 3Vt - to 4-hour Clean Time.
• Heavy spillovers should be cleaned up before starting clean cycle.
“door” APPEARS
ON DISPLAY .Oven door not closed after self-clean cycle selected.
“F-” AND A
NUMBER FLASH
ON DISPLAY
.If “F-” and a number flash on display and the control beeps, this indicates a funetion
error code. Press the CLEAR/OFF pad. Allow oven to cool for one hour. Put oven
back into operation. If funetion error code repeats, disconnect power to the oven.
Call for service.
“OFF” APPEARS
ON DISPLAY
.Oven is too hot for Self-Clean.
• Bake or Broil attempted too soon after Self-Clean.
.Other oven is in Self-Clean.
• Child Lockout feature turned on.
If you need more help. ..call, toll free:
GE Answer Center®
800 . 626.2000
consumer information service
22