Crimestopper Security Products CS-882 User Manual
Page 6
2 3
1
4
ON
NEGATIVE VALIDATION INPUTS
(TOP EDGE OF 882 MODULE)
2 3
1
4
ON
POSITIVE VALIDATION INPUTS
(TOP EDGE OF 882 MODULE)
DOOR / LOCK & VALIDATION WIRES (TYPICAL INSTALLATION)
VALIDATION WIRES ON (MODE A = DIP SWITCHES 1-3 ON):
The Validation wires serve as a secondary input to prevent the
system from being armed or disarmed simply by pushing the unlock
button on the vehicle.
ARM/DISARM VALIDATION WIRES:
ARMING: The CS-882OEM system will NOT ARM if a NEGATIVE
(or POSITIVE*) pulse is sensed on the GREEN/WHITE wire. (The
Lock button on the door panel vehicle was pressed)
DISARMING: The CS-882OEM system will NOT DISARM if a
NEGATIVE (or POSITIVE*) pulse is sensed on the RED/WHITE
wire. (The Unlock button on the door panel was pressed).
*See Positive/Negative Signal setting diagrams at right and below.
L
U
FACTORY
POWER
LOCK
RELAYS
LOCK
SWITCH
(+) LOCK / MOTOR WIRE
(+) UNLOCK / MOTOR WIRE
YELLOW / BLACK
BLUE / BLACK
GREEN / WHITE
RED / WHITE
+ / - LOCK SWITCH WIRE *
+ / - UNLOCK SWITCH WIRE *
(*Programmable for POS/NEG validation)